Range Rover Evoque: Bulb specification chart
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Technical specifications / Bulb specification chart
Before attempting to replace
a bulb,
ensure that both the affected lamp and
the vehicle's ignition, are turned off. If
the circuit remains live, a short circuit
can occur which may damage the
vehicle's electrical system.
Note: LED bulbs can be replaced only by a Land Rover Dealer/Authorised Repairer.
READ NEXT:
Smart key system transmitters
1. Steering column backup transmitter.
2. Front cockpit transmitters.
3. Front exterior door handle transmitters.
4. Roof keyless receiver.
5. Floor console front transmitter.
6. Rear exterior
SEE MORE:
A-Pillar Outer Panel
Removal
NOTES:
The A-pillar outer panel is manufactured from mild steel. The fender
mounting bracket is serviced on the new panel.
The upper and lower butt joint must be MIG brazed due to the location of a boron
reinforcement.
A new anti tamper VIN indentification decal will be required when rep
Loadspace Trim Panel
CAUTION: LH illustration shown, RH is similar.
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1.
2.
3.
4. Torque: 1.4 Nm
5. Torque: 20 Nm
6. NOTE: LH side only.
7.
5-door
8.
9. CAUTION: Take extra care not to damage the
clips.
Release the lower retainin
© 2011-2025 Copyright www.rrevoque.org
