Range Rover Evoque: Deactivating the alarm when triggered
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Entering the vehicle / Deactivating the alarm when triggered
If the alarm has been triggered, it can be deactivated by any one of the following methods: - Pressing the unlock button on the Smart Key.
- Opening a door using keyless entry.
- Positioning a valid Smart Key underneath the steering column and pressing the START/STOP button. See previous graphic.
READ NEXT:
Smart key system transmitters
Any person fitted with an
implanted
medical device should ensure that the
device is kept at a distance of at least
22 cm (8.7 inches) away from any
transmitter mounted in the vehicle.
This is
Steering column lock
During vehicle recovery, a
Smart Key
must remain inside the vehicle, so that
the steering column remains unlocked.
See 216, RECOVERY.
Your vehicle is fitted with an electronic steering
column
Deselecting valet mode
If Valet mode is active when you enter the
vehicle, touch the Valet button to view the
Valet mode screen.
Enter your four digit PIN and touch the OK
button.
Valet mode is deactivated is displayed
SEE MORE:
C-Pillar Upper Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3.
4.
5. Torque: 6 Nm
6.
Installation
1. To install, reverse the removal procedure.
C-Pillar Lower Trim Panel
Removal
1. Refer to: Rear Seat Cushion (501-10 Seating, Removal and
Installation).
2. Refer to: Lo
Body Repairs - Corrosion Protection
Corrosion Protection
Galvanic Corrosion
Galvanic corrosion is the cross-contamination of dissimilar metals, in this
case aluminium and steel. Avoidance of galvanic
corrosion is an important issue to be considered in the repair of aluminium
bodied vehicles.
Precautions to prevent the contamination
© 2011-2025 Copyright www.rrevoque.org
