Range Rover Evoque: Entry gate programming
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Garage door opener / Entry gate programming
The technology of some entry gates requires you to press and re-press (cycle) the hand-held transmitter button every two seconds during programming.
Continue to press and hold the desired HomeLink button while you cycle your hand-held transmitter until the indicator lamp flashes rapidly.
READ NEXT:
Information and assistance
It is recommended that when
you sell or
dispose of the vehicle, the programmed
HomeLink buttons be erased for
security purposes.
For information on the range of available
compatible products or
Instrument panel
Instrument panel
1. Speedometer.
2. Driver Information Centre (message centre).
3. Tachometer.
4. Temperature gauge
Serious engine damage can
occur if
the vehicle is driven while the
engin
Vehicle information and settings menu
Vehicle information and settings menu
A number of vehicle features and display
settings may be configured via the vehicle
information and settings menu.
To display and navigate through the vehic
SEE MORE:
Transfer Case Seal
RH GTDi 2.0L Petrol
Special Tool(s)
100-012
Slide Hammer
205-872
Installer, Transfer Case Seal
308-615
Remover, Seals
308-617
Depth Drill, Seal Remover
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
alway
Automatic switch off
Cruise control will switch off but the set speed
will remain in the memory when:
- The CAN button (3) is pressed.
- The brake pedal is pressed.
- Speed falls below 30km/h (18mph).
- Neutral, Park or Reverse gear is selected
on vehicles with automatic transmission.
- Dynamic Stability Control
© 2011-2025 Copyright www.rrevoque.org
