Range Rover Evoque: Floor Console Upper Section
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. CAUTION: The procedure must be carried out on both sides.
NOTE: LH illustration shown, RH is similar.
Torque: 1.9 Nm
Vehicles with manual transmission
2. Refer to: Gearshift Lever Knob (308-06 Manual Transmission/Transaxle External Controls, Removal and Installation).
3. CAUTION: Carefully release the retaining clips.
4.
5. CAUTION: Carefully release the retaining clips.
Vehicles with automatic transmission
6. CAUTION: Carefully release the retaining clips.
7.
All vehicles
8. NOTE: Do not disassemble further if the component is removed for access only.
Torque:
M5 bolt 1.5 Nm
Screw 1.1 Nm
9. Torque: 1.1 Nm
10. Torque: 1.1 Nm
11. Torque: 1.1 Nm
12. Torque: 1.1 Nm
Installation
1. To install, reverse the removal procedure.
2. Connect Land Rover approved diagnostic equipment to vehicle. Read and clear the stored DTCs.
Torque Specifications
READ NEXT:
Locks, Latches and Entry Systems
Principle of Operation
For a detailed description of the locks, latches and entry systems and
operation, refer to the relevant Description and
Operation section of the workshop manual REFER to: Handl
SEE MORE:
Fender Apron Upper Panel
Removal
NOTES:
The fender apron upper panel is manufactured from mild steel.
The service panel is serviced not fully spot welded.
There is an NVH component on this panel, it is serviced on the new panel.
1. The fender apron upper panel is replaced in conjunction with:
Front bumper cover
Hood
H
Changing the connected phone
Up to 10 mobile phones can be paired with the
vehicle in the same way. However, only one can
be connected and ready for use as a phone at
any one time.
To connect a different paired phone, follow the
steps below:
1. From the Home menu, select Phone.
2. A menu will appear. Select Change phone.
