Range Rover Evoque: Fuel Filler Door
Removal
CAUTION: Make sure to protect the paintwork.
1.
Installation
1.
Fuel Filler Door Assembly
Removal
WARNING: Avoid flames, sparks or lighted substances.
CAUTION: Extreme cleanliness must be exercised when handling these components.
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
Make sure that all openings are sealed. Use new blanking caps.
1. Remove the rear wheel.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
2.
3.
4.
5.
6.
7. CAUTION: Make sure to protect the paintwork.
NOTE: Do not disassemble further if the component is removed for access only.
Installation
1.
2. To install, reverse the removal procedure.
READ NEXT:
Body Closures - Component Location, System Operation and Component
Description
Component Location
Powered Tailgate - Component Location
Tailgate module
Powered strut
Tailgate open button
Tailgate close button
Latch assembly
Powered cinch motor
Powered strut
OVERVIEW
Ta
A-Pillar Trim Panel, B-Pillar Upper Trim Panel 5-Door
A-Pillar Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Torque: 6 Nm
Installation
1. To install, reverse the removal procedure.
B-Pillar Upper Trim Pane
SEE MORE:
Wheel changing safety
Before raising the vehicle or changing a wheel,
ensure that you read and comply with the
following warnings.
Always find a safe place to
stop, off
the highway and away from traffic.
Ensure that the vehicle and jack are
both on firm level ground.
Apply the parking brake. Engage Park
(P) on
Manual Transmission FWD
Component
Location
COMPONENT LOCATION
Manual transmission
Selector lever assembly
Overview
OVERVIEW
The M66EH50 manual transmission is a 6 speed unit manufactured by Getrag-Ford
in Cologne, Germany. The transmission
is a highly compact 4 shaft design, incorporating the front final drive gear.
