Range Rover Evoque: Sand

This program should be used for
terrain which is predominantly soft
dry sand or deep gravel.
Note: If the vehicle is unable to gain traction in
extremely soft, dry sand, switching DSC off
may help. DSC should be switched on again as
soon as the difficulty is overcome.
If the sand to be crossed is damp/wet, and
sufficiently deep to cause the wheels to sink
into the surface, the Mud-Ruts program should
be used.
READ NEXT:
The maximum advisable wading depth is
500mm (19.7in). If the vehicle remains
stationary in water above the door sill level,
severe electrical damage may occur.
Do not switch off the engine when
Although Dynamic Stability Control is
automatically engaged when a special program
is selected, it can be turned off if required. See
91, DISABLING DSC.
Hill Descent Control (HDC) will be
automat
Use of an incorrect program
will impair
the vehicle's response to the terrain and
can reduce the life of the suspension
and drive systems.
If the system becomes partially inoperable for
any re
SEE MORE:
Removal
1. Refer to: Rear Quarter Panel Moulding (501-08 Exterior Trim and
Ornamentation, Removal and Installation).
2. Refer to: B-Pillar Upper Trim Panel - 3-Door (501-05 Interior Trim and
Ornamentation, Removal and Installation).
3. Refer to: D-Pillar Trim Panel (501-05 Interior Trim and
Ornament
Generator - Component
Location
COMPONENT LOCATION
Battery positive connection
LIN (local interconnect network) bus connection
Generator
Generator - Overview
OVERVIEW
A single self-exciting generator is located at the front of the engine on the
LH (left-hand) side of the cylinder block. There
© 2011-2025 Copyright www.rrevoque.org
