Range Rover Evoque: Topping up the coolant
Never remove the filler cap
when the
engine is hot - escaping steam or
scalding water could cause serious
personal injury.
Antifreeze is highly inflammable. Do
not allow antifreeze to come into
contact with naked flames or other
sources of ignition (e.g. a hot engine)
- a fire may result.
Unscrew the filler cap slowly,
allowing the pressure to escape
before removing completely.
When travelling in
territories where the
water supply contains salt, always
ensure you carry a supply of fresh (rain
or distilled) water. Topping up with salt
water will cause serious engine
damage.
Top-up to the MAX indicator mark on the side of the expansion tank. Use only a 50% mix of water and Texaco XLC antifreeze.
Note: In an emergency - and only if the approved antifreeze is unavailable - top-up the cooling system with clean water, but be aware of the resultant reduction in frost protection.
Do not top-up or refill with conventional antifreeze formulations. If in doubt consult a qualified technician.
Ensure the cap is tightened fully after top-up is completed by turning the cap until the ratchet cap clicks.
READ NEXT:
Coolant antifreeze
Antifreeze is poisonous and
can be
fatal if swallowed - keep containers
sealed and out of the reach of
children. If accidental consumption is
suspected, seek medical attention
immediately.
If
Brake/clutch fluid check
Seek qualified assistance
immediately if brake pedal travel is
unusually long or if there is any
significant loss of brake fluid. Driving
under such conditions could result in
extended stopping
Topping up the brake/clutch fluid
Brake fluid will damage
painted
surfaces. Soak up any spillage with an
absorbent cloth immediately and wash
the area with a mixture of car shampoo
and water.
Only use new fluid from an airtigh
SEE MORE:
Engine Oil Draining and Filling, Camshafts
Engine Oil Draining and Filling
Draining
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Remove the engine undershield.
Refer to: Engine Undershield (501-02 Front End Body Panels
Rear Shock Absorber Vehicles Without: Dynamic
Suspension
General Equipment
Suspension Spring Compressor
Vise
Removal
WARNINGS:
Make sure the spring compressor Safe Working Load (SWL) meets or exceeds
the spring rating quoted in the
Specifcations section.
Always follow the spring compressor manufacturer's instructions.
The spring is under extreme te
