Range Rover Evoque: Anti-Lock Control - Stability Assist
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Brake System / Anti-Lock Control - Stability Assist
Accelerometer
Removal
NOTES:
Removal steps in this procedure may contain installation details.
LHD illustration shown, RHD is similar.
Vehicles with automatic transmission
1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).
2. Torque: 9 Nm
Vehicles with manual transmission
3. Refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation).
4.
5.
6. Torque: 9 Nm
Installation
1. To install, reverse the removal procedure.
2. If a new component has been installed, configure using Land Rover approved diagnostic equipment.
READ NEXT:
Power Steering AWD
Component Location
Steering gear
Rubber seal assembly
Heat shield
Overview
The vehicle is fitted with EPS (electric power steering), provided by a ZF
Servolectric steering gear unit with variab
SEE MORE:
Front Bumper Mounting
Removal
NOTE: The front bumper mounting is manufactured from HSLA300 and mild
steel.
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on
an approved alignment jig.
2. The front bumper mounting is replaced in conjunction with:
Front bumper cover
Front bumper
Active On-Demand Coupling Module
Removal
NOTE: If a new Active on-demand coupling module is installed, the throttle
valve must also be installed.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2.
3. CAUTIONS:
Make sure that the area around the component is
clean and free of foreign m
© 2011-2025 Copyright www.rrevoque.org
