Range Rover Evoque manuals

Range Rover Evoque: Direction indicator and side lamp bulbs

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Maintenance / Direction indicator and side lamp bulbs

Removing the nearside bulbs;

To gain more room for accessibility, follow

To gain more room for accessibility, follow steps 1 and 2 for moving the nearside headlamp unit.

1. At the back of the headlamp unit, remove the indicator bulb housing. Turn it counter clockwise to release.

2. To remove the side lamp bulb housing.

Turn it counter clockwise to release.

Removing the offside bulbs;

To gain more room for accessibility, follow the

To gain more room for accessibility, follow the process for moving the offside headlamp unit.

1. At the back of the headlamp unit, remove the indicator bulb housing. Turn it counter clockwise to release.

2. To remove the side lamp bulb housing.

Turn it counter clockwise to release.

READ NEXT:

 Rear lamp bulbs

1. Remove the two fixings. 2. Direction indicator. 3. Reversing lamp Turn the relevant bulb holder counter clockwise and pull to remove from the lamp unit. Grip the holder then press the bulb i

 Rear fog lamp

Access to the rear fog lamp requires special tools and should be undertaken only by a qualified technician. If in doubt, consult your Land Rover Dealer/Authorised Repairer.

 Cleaning the exterior

Remove any heavy deposits of mud and dirt with a hose before washing the vehicle. Never aim a hose water jet directly at the engine air intake, heater air intakes, body seals or at any compone

SEE MORE:

 Overhead Console

Removal NOTE: Removal steps in this procedure may contain installation details. 1. CAUTION: Take extra care not to damage the edges of the component. 2. 3. NOTE: Do not disassemble further if the component is removed for access only. 4. CAUTION: Take extra care not to damage the wiring harnesses.

 A-Pillar Outer Panel

Removal NOTES: The A-pillar outer panel is manufactured from mild steel. The fender mounting bracket is serviced on the new panel. The upper and lower butt joint must be MIG brazed due to the location of a boron reinforcement. A new anti tamper VIN indentification decal will be required when rep

© 2011-2025 Copyright www.rrevoque.org