Range Rover Evoque: Dual view selection
When the ignition is switched on or the audio
unit is turned on after being turned off, single
view mode will be the default view.
To select dual view, press the dual view hard
key on the fascia surround. See 111,
AUDIO/VIDEO CONTROLS.
Press again to display the dual view Options
menu. From here, a change can be made to the
viewing source or dual view can be cancelled.
If TV or a video format source were being
viewed previously, the same source will be
displayed.
READ NEXT:
Dual view control menu
1. Select to cancel dual view and revert to the
menu for the current video source (TV,
DVD).
Note: The preview screen will be
deactivated if the vehicle is moving.
2. Se
If you would like to change the TV programme
while the vehicle is moving, there are two
methods available;
1. Press the dual view hardkey to display the
control menu.
Select an alternative channe
When the video programme begins play, a root
menu with information about the video
programme and its content will be displayed on
screen.
Note: Information and style may vary due to
differing vid
SEE MORE:
Component Location
Stabilizer link
RH (right-hand) spring and damper assembly
Stabilizer bar
LH (left-hand) spring and damper assembly
Wheel knuckle
Stub axle and locknut
Hub
Longitudinal link
Rear transverse link
Front transverse link
Front Wheel Drive (FWD) Rear Subframe
Overview
The
Component Location
NOTE: RHD (right-hand drive) installations shown; LHD (left-hand drive)
installations similar.
COMPONENT LOCATION - SHEET 1 OF 2
RH (right-hand) front wheel speed sensor
RH rear wheel speed sensor
LH (left-hand) rear wheel speed sensor
LH front wheel speed sensor
Integrate
© 2011-2025 Copyright www.rrevoque.org
