Range Rover Evoque: Electronic brake distribution (EBD)
EBD controls the balance of braking forces
supplied to the front and rear wheels, in order
to maintain maximum braking efficiency.
If the vehicle has a light load (only the driver in
the vehicle for example), EBD will reduce the
braking force applied to the rear wheels. If the
vehicle is heavily laden, EBD will allow greater
braking force to the rear wheels.

The red brake warning lamp
illuminates briefly when the
ignition is turned on.
A fault with the EBD system is indicated by the
red brake warning indicator illuminating and an
associated warning message. Gently and safely
stop the vehicle and seek qualified assistance.
READ NEXT:
The parking brake operates on
the rear
wheels. Therefore, secure parking of
the vehicle is dependent on being on a
hard and stable surface.
Do not rely on the parking brake to
operate effectiv
Epb manual use
1. To apply the parking brake, with the vehicle
stationary, pull up the lever and release it.
The parking brake warning
lamp will illuminate. It is
important to confirm that th
EPB will be applied automatically if the ignition
is switched off and the vehicle speed is below
3km/h (2mph).
To prevent automatic operation, when the
vehicle is stationary, press and hold the EP
SEE MORE:
Windscreen wipers
1. Rotate the collar to adjust the intermittent
period. The intermittent delay period will
vary and is controlled by either vehicle
speed or a rain sensor. The control must be
in position (4) to be operational. This is a
dealer configurable option.
2. High speed wipe.
3.
Introduction
CAUTION: Do not use any other heat shrink sleeve other than the approved
glue lined heat shrink sleeve mentioned
in the repair procedure.
The purpose of this document is to promote quick and efficient minor repair
to harness connectors or cables using
approved methods and the wiring
© 2011-2025 Copyright www.rrevoque.org
