Range Rover Evoque: Engine Upper/Lower Support Insulator

Engine Upper Support Insulator

Removal

NOTES:

Removal steps in this procedure may contain installation details.

Some variation in the illustrations may occur, but the essential information is always correct.

1. Refer to: Engine Mount RH (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).

2. Torque: 10 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

3. Torque: 80 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

Installation

1. To install, reverse the removal procedure.

Engine Lower Support Insulator

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).

3. CAUTION: Discard the bolts.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

4. CAUTION: Discard the bolt.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

Installation

1. CAUTIONS:

Make sure that a new bolt is installed.

Only tighten the bolt finger-tight at this stage.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

2. CAUTIONS:

Make sure that new bolts are installed.

Install all the bolts finger tight before final tightening.

Torque:

READ NEXT:

 Oil Filter Housing

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this proc

 Balance Shaft Assembly

Special Tool(s) JLR-303-1595 Alignment Tool, Crankshaft Damper Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essent

 Engine - Diagnosis and Testing

Principles of Operation For a detailed description of the engine system, refer to the relevant Description and Operation section in the workshop manual. REFER to: (303-01B Engine - GTDi 2.0L Petrol)

SEE MORE:

 Gear shift indicator

The gear shift indicator illuminates briefly at the recommended gear change point (upshift). The shift indicator will not illuminate while Cruise control is active and is not being overridden by pressing the throttle pedal. Note: This warning indicator is only a guide. It remains the respo

 Cylinder Head

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. 1. Refer to: Battery Tray (414-01 Battery, Mounting and Cables, Removal and Installation). 2. Refer to: Cooling System Draining

© 2011-2025 Copyright www.rrevoque.org