Range Rover Evoque: Interior lights locations
Interior lights locations
1. Sun visor lamps. Illuminates when the vanity mirror is opened.
2. Map reading lamps. Move a finger close to (or touch) the relevant lens to switch on/off.
Note: If you are wearing gloves, it may be necessary to touch the lens to operate the lamps.
3. Front interior lamp. Illuminates when the doors are unlocked and extinguishes 60 seconds after all doors are closed, when the engine starts or when the vehicle is locked. Move a finger close to (or touch) the lens to switch on and off manually.
Touch the lens for two seconds to deactivate/activate automatic illumination.
4. Glove box lamp. Illuminates when the glove box is opened.
5. Footwell lamps. Illuminates when the doors are unlocked and extinguishes 60 seconds after all doors are closed, when the engine starts or when the vehicle is locked.
6. Rear interior/reading lamps. Illuminates when the doors are unlocked and extinguishes 60 seconds after all doors are closed, when the engine starts or when the vehicle is locked. Press the switch to switch on and off manually. Touch the front courtesy lamp lens for approximately 2 seconds to deactivate/activate automatic illumination of the rear interior lamps.
7. Luggage compartment lamp. Illuminates when the tailgate is opened.
READ NEXT:
Interior lights intensity
While the exterior lamps are turned on,
intensity of interior lights can be adjusted. See
248, CONTROLS, Interior illumination control.
Ambient lighting
The LED ambient lighting can be adjusted for
colour and intensity via the touch screen. The
exterior lamps must be turned on while
changes are being made via the touch screen.
See 104, TOUCH SCREE
SEE MORE:
Shock Absorber and Spring Assembly Vehicles With:
Dynamic Suspension
Special Tool(s)
205-754A
Splitter, Ball Joints
205-857
Remover, Halfshaft
JLR-204-804
Lever, Wheel Knuckle
General Equipment
Transmission jack
Wooden Block
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle
on the suspension.
NOTE: Some variation in the illustratio
Headlamps
Moving the nearside headlamp unit to access
bulbs;
1. Remove the two plastic fixings.
2. Pull the tube up to release from the air box.
This will allow more room for
manoeuvrability.
3. Remove the four grille fixings.
4. Remove the two retaining bolts.
5. At the rear of the headlamp unit, p
