Range Rover Evoque: Rain sensor/speed sensitive wiper control
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Wipers and washers / Rain sensor/speed sensitive wiper control
Intermittent operation of the wipers is controlled initially by either vehicle speed or a rain sensor located at the upper edge of the windscreen. Both methods of control will clear the screens adequately. Vehicle speed control is set by the user and control via a rain sensor is automatic.
This function can be
enabled/disabled
by your Dealer/Authorised Repairer.
READ NEXT:
Rain sensor
Ensure that the wipers are
switched off
before entering a car wash. If the rain
sensitive wipers operate during the car
washing process, damage may occur to
the wiper mechanism.
The rain senso
Speed sensitive wipers
If vehicle speed drops below 6km/h (3.7mph)
with the wipers operating in positions (2) or
(3), the wipers will switch to the next lowest
speed. When vehicle speed increases to over
6km/h (3.7mph),
Drip wipe
If the drip wipe function is configured, the
wipers will operate four seconds after a
wash/wipe cycle has finished, to clear any
remaining drips from the windscreen.
This function can be enabled
SEE MORE:
Inner Constant Velocity (CV) Joint Boot
Special Tool(s)
303-D121
Puller, General Purpose
General Equipment
Vise
Removal
NOTE: RH inner constant velocity joint boot shown, LH is similar.
1. Refer to: Front Halfshaft LH (205-04 Front Drive Halfshafts, Removal
and Installation).
Refer to: Front Halfshaft RH - LHD AWD/RHD AWD (205-04 Fron
Front Bumper Mounting
Removal
NOTE: The front bumper mounting is manufactured from HSLA300 and mild
steel.
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on
an approved alignment jig.
2. The front bumper mounting is replaced in conjunction with:
Front bumper cover
Front bumper
© 2011-2025 Copyright www.rrevoque.org
