Range Rover Evoque: Releasing locking wheel nuts
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Wheel changing / Releasing locking wheel nuts
1. Insert the wheel nut adapter into the locking wheel nut, ensuring that it is fully engaged.
2. Locate the wheel brace over the adapter and unscrew the wheel nut half a turn counter clockwise.
3. After raising the vehicle on the jack, remove the locking wheel nut.
Note: After use store the wheel nut adapter correctly in the tool kit.
READ NEXT:
Wheel changing
WARNING - THAT NO PERSON
SHOULD PLACE ANY PORTION OF
THEIR BODY UNDER A VEHICLE THAT
IS SUPPORTED BY A JACK.
Position the jack from the side of the
vehicle, in line with the appropriate
jacking
Tyre care
Do not drive the vehicle if a
tyre is
damaged, excessively worn, or
incorrectly inflated.
Avoid contaminating the tyres with
vehicle fluids as they may cause
damage to the tyre.
Avoid spinnin
SEE MORE:
Evaporator LHD
Removal
NOTES:
The removal of this component involves cutting an aperture in the evaporator
housing wall and cutting through the
high and low pressure A/C lines. A service repair kit is supplied to cover this
procedure.
Removal steps in this procedure may contain installation details.
1. Disconne
Transmission Control Module (TCM)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle
NOTES:
If the control module or a component
© 2011-2025 Copyright www.rrevoque.org
