Range Rover Evoque manuals

Range Rover Evoque: Rolling code device equipment programming

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Garage door opener / Rolling code device equipment programming

Note: The assistance of a second person, may make the following steps quicker and easier.

Once the button has been pressed there are only 30 seconds in which to complete Step 3.

1. At the garage door opener receiver (motor head unit) in the garage, locate the learn or smart button/switch.

- The name of the button or switch may vary between manufacturers.

2. Press and release the learn or smart button.

3. In your vehicle, firmly press the previously programmed HomeLink opener button twice and release.

4. Press and hold briefly to complete the programming process.

HomeLink should now activate the rolling code device.

READ NEXT:

 Reprogramming a single garage door opener button

To programme a device to a previously programmed button: 1. Press and hold the desired pre-programmed HomeLink button for at least 20 seconds, but no longer than 30 seconds, until the indicator l

 To erase all programming

For first time programming, ensure that the engine is switched off: 1. Ensure that the ignition is on (but with the engine switched off). 2. Press and hold the two outer HomeLink buttons. Keep th

 Entry gate programming

The technology of some entry gates requires you to press and re-press (cycle) the hand-held transmitter button every two seconds during programming. Continue to press and hold the desired HomeLin

SEE MORE:

 Transmission GTDi 2.0L Petrol - Installation

Installation NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. NOTE: This step is only required if previously removed. Torque: 12 Nm 2. NOTE: This step is only required if previously removed. 3. CAUTION: Make sure that the seal is correctly

 Manual Transmission FWD

Component Location COMPONENT LOCATION Manual transmission Selector lever assembly Overview OVERVIEW The M66EH50 manual transmission is a 6 speed unit manufactured by Getrag-Ford in Cologne, Germany. The transmission is a highly compact 4 shaft design, incorporating the front final drive gear.

© 2011-2025 Copyright www.rrevoque.org