Range Rover Evoque: Seat belt safety

contamination of the webbing with Care should be taken to avoid contamination of the webbing with polishes, oils and chemicals, and particularly battery acid. Cleaning may safely be carried out using mild soap and water.
The belt should be replaced if webbing becomes frayed, contaminated or damaged.
It is essential to replace the entire assembly after it has been worn in a severe impact even if damage to the assembly is not obvious.
If any damage, wear, cuts, defects, or impaired operation are noted with the seat belts, the vehicle should be taken to a Land Rover Dealer/Authorised Repairer for immediate attention. Do not use the vehicle if the seat belts cannot be operated correctly.
Do not carry hard, fragile, or sharp items between your person and the seat belt.
Seat belts should be worn by all vehicle occupants, for every journey no matter how short.
Never wear just the lap belt or just the shoulder belt of a lap/shoulder diagonal seat belt. Both of these actions are extremely dangerous and may increase your risk of injury.
When using seat belts to restrain items other than occupants, take care to ensure that the belts are not damaged, or exposed to sharp edges.

READ NEXT:

 Seat belt checks

Note: If the vehicle is parked on an incline, the seat belt mechanism may lock. This is not a fault and the belt should be gently eased out from the upper anchorage. The seat belts should be inspe

 Seat belt reminder

Seat belt reminder If a front seat belt is not fastened when the vehicle is in motion, a chime will be heard and the seat belt warning lamp will illuminate. Note: Objects on the front passenger

 Beltminder

A front and rear seat Beltminder system warns the driver when the seat belt of an occupied seat is not fastened or is unfastened during a journey. Beltminder A graphic accompanied by a text mes

SEE MORE:

 Hydraulic Brake Actuation

Hydraulic Brake Actuation LHD AWD/RHD AWD - Component Location NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive) installation similar. COMPONENT LOCATION Brake pedal Hydraulic pipes Integrated HCU (hydraulic control unit) and ABS (anti-lock brake system) module Brake ma

 Control Diagram

NOTES: A = Hardwired; N = Medium Speed CAN (controller area network) bus; D = High Speed CAN bus; T = Coaxial; O = LIN (local interconnect network) bus; P = Fibre Optic MOST; AD = NSTC; AE = LVDS; Park assist is not available to all markets. CONTROL DIAGRAM - SHEET 1 OF 3 - PARKING AID AND PARK ASS

© 2011-2025 Copyright www.rrevoque.org