Range Rover Evoque: Suspending and resuming cruise control

Suspend cruise control with a single press of control (3).

To resume cruise control at the previous set speed, press control (2).

if the RES (2) should be used only if the driver is aware of the set speed and intends to return to it.
It is not recommended to resume set speed when a low gear is selected as excessive engine speeds will occur.

READ NEXT:

 Automatic switch off

Cruise control will switch off but the set speed will remain in the memory when: - The CAN button (3) is pressed. - The brake pedal is pressed. - Speed falls below 30km/h (18mph). - Neutral, Park

 Cruise eco data

Diesel only When enabled, a CO2 emission indicator is displayed in the message centre. The higher the numeric reading, the more CO2 is being emitted and the more fuel is being used. See 56, VEH

 Stability control

SEE MORE:

 Headlamp Assembly

Removal NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. 3. 4. NOTE: Some components shown removed for clarity. 5. 6. 7. 8. 9. Remove all bumper lower fixing to assist the

 Anti-Theft - Active

Anti-Theft - Active - Component Location COMPONENT LOCATION RH (right-hand) front door module RH front door latch mechanism Radio Frequency (RF) receiver RH rear door module RH rear door latch mechanism Interior motion sensor Remote handset Liftgate latch mechanism Keyless Vehicle Module

© 2011-2025 Copyright www.rrevoque.org