Range Rover Evoque: Battery - Removal and Installation
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Battery and Charging System / Battery, Mounting and Cables / Battery - Removal and Installation
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
1.
2.
3. Torque: 25 Nm
4. Torque: 25 Nm
5.
6. Torque: 6 Nm
7. NOTE: If equipped.
Torque: 10 Nm
8.
9. Torque: 6 Nm
10. Torque: 6 Nm
11.
12.
13.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Battery Tray
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Refer to: Battery
Generator and Regulator - GTDi 2.0L Petrol
Generator - Component
Location
COMPONENT LOCATION
Battery positive connection
LIN (local interconnect network) bus connection
Generator
Generator - Overview
OVERVIEW
A single self-exciting gener
SEE MORE:
Transfer Case
Connecting Sleeve Seals GTDi 2.0L Petrol
Special Tool(s)
100-012
Slide Hammer
307-594
Installer, Seal
308-005
Remover, Axle oil seal
Removal
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2.
Differential Draining and Filling
1. WARNING: Make sure to support the vehicle with axle stands.
CAUTION: Make sure the vehicle is on a flat level surface.
Raise and support the vehicle.
2. No provision is made to fully drain the rear differential.
During repair procedures, fluid will be lost. A container
should be positioned to c
© 2011-2025 Copyright www.rrevoque.org
