Range Rover Evoque: Commandshift™

To return to Sport mode after CommandShift has been selected, move the selector back to D then back to Sport mode. Transmission Commandshift Selected will appear in the message centre when the transmission is in CommandShift mode.

Note: In order to protect the engine, the transmission will automatically change up to prevent over-revving, or down if the engine is labouring.

READ NEXT:

 Kick-down

Push the accelerator pedal fully down to achieve rapid acceleration in automatic mode. When the pedal is relaxed, normal gear changing will resume.

 Drive selector

P should normally be selected before switching off the engine. If any other gear is selected at turn off, the selector will move to P before retracting into the centre console. If the engine is sw

 Drive selector fails to elevate

If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal. If the selector still fails to elevate, even if there is no obstructio

SEE MORE:

 Intake Air Distribution and Filtering - GTDi 2.0L Petrol

Intake Air Distribution and Filtering - Component Location COMPONENT LOCATION Purge hose from charcoal canister Clean air purge hose Clean air inlet ducts Camshaft cover vent pipe connection Sound generator duct Sound generator Air cleaner housing Dirty air intake duct Sound generator hos

 Drive Pinion Flange Vehicles With: AWF21 6-Speed Automatic Transmission

Special Tool(s) 205-053 Retainer, Drive Flange Removal All vehicles 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. Vehicles with diesel engine 2. Refer to: Exhaust System (309-00B Exhaust System - TD4 2.2L Diesel, Removal and Installation). Vehicles wit

© 2011-2025 Copyright www.rrevoque.org