Range Rover Evoque: Dynamic stability control (DSC)
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Stability control / Dynamic stability control (DSC)
DSC is automatically enabled each time the engine is started, and is automatically enabled by some of the Terrain response special programs.
The vehicle is not designed
for
cornering at the same speed as
conventional passenger cars any
more than a low-slung sports car is
designed to perform satisfactorily
under off-road conditions. If at all
possible, avoid sharp turns or abrupt
manoeuvres. As with other vehicles of
this type, failure to operate the
vehicle correctly may result in loss of
control or vehicle rollover.
READ NEXT:
Dsc warning lamp
The amber DSC warning lamp in
the instrument panel illuminates
briefly when the ignition is
switched on and extinguishes when the engine
is started.
If the lamp flashes while driving, the DSC
Disabling dsc
Safety may be reduced by
inappropriately disabling DSC. In the
majority of driving situations, and
particularly on-road, it is
recommended that you do not disable
DSC.
In some driving condition
Re-enabling dsc
DSC is re-enabled by one of the following:
- Press and briefly hold the DSC OFF switch.
- Stop and restart the engine.
- Select a new Terrain Response special
program.
SEE MORE:
Rear Halfshaft RH
Special Tool(s)
205-857
Remover, Halfshaft
205-928
Remover, Half Shaft Inboard Joint
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
suspension.
Do not allow halfshafts to hang unsupported at one end or joint damage will
occur.
Make sure the halfshaft con
Settings - options
- If the Link DAB setting is switched on and
the signal strength for a channel falls below
an acceptable level, the audio unit will
automatically search other available
ensembles for a channel with the same
name.
If an alternative local channel is found, the
new channel is played automaticall
© 2011-2025 Copyright www.rrevoque.org
