Range Rover Evoque: Front Seat Height Adjustment Motor

Removal

NOTE: Removal steps in this procedure may contain installation details.

All vehicles

1. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. WARNING: To avoid accidental deployment, the restraints control module backup power supply must be depleted. Wait at least two minutes after disconnecting the battery ground cable(s) before commencing any repair or adjustment to the supplemental restraint system (SRS), or any component(s) adjacent to the SRS sensors.

Failure to follow these instructions may result in personal injury.

Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).

3. Refer to: Front Seat Control Switch (501-10 Seating, Removal and Installation).

4. Refer to: Front Seat (501-10 Seating, Removal and Installation).

5. CAUTION: Note the fitted position of the component prior to removal.

Vehicles with sports seats

6.

7. CAUTION: Note the fitted position of the component prior to removal.

Vehicles with heated front seats

8. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.

Non NAS vehicles

9. CAUTION: Make sure that the component is aligned and attached as shown.

NAS vehicles

10.

All vehicles

11. NOTE: If equipped.

12.

13.

14. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.

Torque: 28 Nm

15. Torque: 28 Nm

16. NOTES:

Use a suitable tool to remove the circlips from the seat cushion frame bolts.

Repeat the procedure for the other side.

17. NOTES:

Right-hand shown, left-hand similar.

Repeat the procedure for the other side.

Torque: 20 Nm

18.

19. NOTES:

Note the orientation of the components.

Right-hand shown, left-hand similar.

20.

21. Torque: 10 Nm

Installation

1. To install, reverse the removal procedure.

READ NEXT: