Range Rover Evoque: Replacement sensor
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Tyre pressure monitoring system / Replacement sensor
Should the sensor require replacing, it should be carried out by a Dealer/Authorised Repairer.
A replacement sensor must be fitted to a running wheel in order to be recognised by the system. The vehicle needs to be stationary for 15 minutes during the sensor fitment before the system is ready to detect the new sensor.
The vehicle must be driven for a minimum of fifteen minutes after the sensor change, and then remain stationary for fifteen minutes to activate full TPM system operation.
If the TPM system warning for any wheel does not clear, even after ensuring correct inflation and driving for more than ten minutes above 25 km/h (18 mph), you should seek qualified assistance as soon as possible.
READ NEXT:
Tyre repair kit
If you are in any doubt
regarding your
ability to carry out the instructions,
contact your Dealer/Approved
Repairer before attempting the repair.
Your vehicle may not be equipped with a spare
Safety information
Some tyre damage may only be
partially sealed, or may not seal at
all, depending on the amount and type
of damage. Any loss of tyre pressure
can seriously affect vehicle safety.
Do not use the t
SEE MORE:
Interior mirror
Auto dimming mirror
1. Ambient light sensor.
2. High beam assist sensor.
Interior mirror dimming will adjust
automatically according to the amount of
ambient light when the ignition is on. If reverse
gear is selected, the automatic dimming
feature is turned off to allow maximum
visibility
Automatic systems
Gradient Acceleration Control (GAC) and Hill
Start Assist are not active while HDC is
operating.
GAC will limit vehicle acceleration on steep
descents, allowing the driver to feel more in
control of the vehicle.
Hill Start Assist activates when starting a hill
ascent from a stationary positio
© 2011-2025 Copyright www.rrevoque.org
