Range Rover Evoque: System fault
If a fault with one of the radar sensors is detected, an amber warning indicator dot is displayed in the exterior mirror and the message BSM not available is displayed in the message centre.
Note: Even if the detected fault only affects the radar sensor on one side of the vehicle, the whole system is disabled. If the fault is temporary, the system will operate correctly once the engine has been switched off and then on again.
If a fault in the system occurs, consult your Dealer/Authorised Repairer.
READ NEXT:
Garage door transceiver
Do not use the transceiver
with any
garage door opener that lacks the
safety stop and reverse feature as
required by safety standards.
When programming the transceiver to
a garage door opener
Before programming
When programming a device
that may
require you to press and re-press the
hand-held transmitter (cycle), unplug
the device during the cycling process to
prevent possible motor failure.
For best
SEE MORE:
Starting a disabled vehicle using a starting aid
To start the vehicle using a starting aid or a
slave battery, follow the instructions in the
sequence given.
1. Connect the positive (Red) booster cable to
the positive (+) battery terminal of the
discharged battery.
2. Connect the negative (Black) booster cable
to the vehicle earth point.
3
Engine Cooling - Diagnosis and Testing
Principles of Operation
For a detailed description of the cooling system, refer to the relevant
Description and Operation section in the workshop
manual. REFER to: (303-03B Engine Cooling - GTDi 2.0L Petrol)
Inspection and Verification
CAUTION: Diagnosis by substitution from a donor vehicle is NOT
© 2011-2025 Copyright www.rrevoque.org
