Range Rover Evoque: Transfer Case Rear Seal

Special Tool(s)

100-012
Slide Hammer

205-871
Installer, Transfer Case Rear Seal

308-615
Remover, Seals

308-617
Depth Drill, Seal Remover

Removal

NOTES:

Removal steps in this procedure may contain installation details.

Some variation in the illustrations may occur, but the essential information is always correct.

All vehicles

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

Vehicles with diesel particulate filter (DPF)

2.

All vehicles

3. CAUTIONS: Mark the position of the driveshaft flange in relation to the drive pinion flange.

Make sure that the driveshaft is supported with suitable retaining straps.

Torque: 40 Nm

4. CAUTION: Make sure that a new bolt is installed.

Torque: 48 Nm

5.

• Special Tool(s): 308-617

6. CAUTIONS: Make sure that the area around the component is clean and free of foreign material.

Take extra care not to damage the mating faces.

• Special Tool(s): 308-615
• Special Tool(s): 100-012

Installation

1.

• Special Tool(s): 205-871

2. To install, reverse the removal procedure.

3. Check and top-up the transfer case fluid level.

Refer to: Transfer Case Fluid Level Check (308-07B Transfer Case - Vehicles With: AWF21 6-Speed Automatic Transmission/M66 6-Speed Manual Transmission AWD, General Procedures).

READ NEXT: