Range Rover Evoque: Urban cycle

The urban test cycle is carried out from a cold start and consists of a series of accelerations, decelerations and periods of steady speed driving and engine idling. The maximum speed attained during the test is 50km/h (30mph) with an average speed of 19km/h (12mph).

READ NEXT:

 Extra-urban cycle

The extra-urban test cycle is carried out immediately after the urban test. Approximately half of the test comprises steady speed driving, while the remainder consists of a series of acceleration

 Combined

The combined figure is an average of the urban and extra-urban test cycle results, which has been weighted to take account of the different distances covered during the two tests. For additional

 Maintenance

SEE MORE:

 Inner Constant Velocity (CV) Joint Boot

Special Tool(s) 303-D121 Puller, General Purpose General Equipment Vise Removal NOTE: RH inner constant velocity joint boot shown, LH is similar. 1. Refer to: Rear Halfshaft LH (205-05 Rear Drive Halfshafts, Removal and Installation). Refer to: Rear Halfshaft RH (205-05 Rear Drive Halfshafts, Re

 Front Seat Cushion Cover

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. Prior to carrying out the step by step procedure below, Steps 2 and 3 must be followed for knowledge on how to correctly install and care for the seat cover. 2. 3. 4. If required, follow the steps below

© 2011-2025 Copyright www.rrevoque.org