Range Rover Evoque: Fuel Fired Booster Heater FWD

Component Location

COMPONENT LOCATION - VEHICLES WITHOUT FFBH REMOTE CONTROL

  1. ATC (automatic temperature control) module
  2. Fuel Fired Booster Heater (FFBH)
  3. Auxiliary coolant pump
  4. Ambient air temperature sensor
  5. Auxiliary fuel pump

COMPONENT LOCATION - VEHICLES WITH FFBH REMOTE CONTROL

  1. ATC module
  2. Fuel Fired Booster Heater (FFBH)
  3. Auxiliary coolant pump
  4. Ambient air temperature sensor
  5. Auxiliary fuel pump
  6. FFBH Receiver
  7. FFBH antenna matching unit

Overview

OVERVIEW

NOTE: There is no auxiliary coolant pump fitted if there is no FFBH fitted (from VIN 631090).

The Fuel Fired Booster Heater (FFBH) is rated at 5 kW and compensates for the relatively low coolant temperatures inherent in the diesel engine. The unit is located behind the RH (right-hand) front fender splash shield and heats engine coolant downstream of the heater core.

Operation of the FFBH is controlled by the ATC (automatic temperature control) module via the medium speed CAN (controller area network) bus. The operation of the FFBH is influenced by:

The FFBH will operate if the ambient air temperature is lower than 5

READ NEXT:

 Instrumentation and Warning Systems

 Instrument Cluster

Instrument Cluster - Component Location COMPONENT LOCATION Instrument Cluster - Overview OVERVIEW The instrument cluster comprises two analogue gages for the speedometer and the tachometer and a 5 i

 Information and Message Center

Information and Message Center - Component Location COMPONENT LOCATION Information and Message Center - Overview OVERVIEW The message center is located in the instrument cluster, in a central positio

SEE MORE:

 Changing a fuse

Always turn off the ignition system and the affected electrical circuit, before replacing a fuse. Fit Land Rover approved replacement fuses of the same rating and type, or fuses of matching specification. Using an incorrect fuse, may result in damage to the vehicle's electrical system and

 Transmission Vehicles With: M66 6-Speed Manual Transmission AWD - Installation

Installation Special Tool(s) 303-021 Engine support bracket 303-662 Support Beam Arm and Hook Assembly, Engine NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. NOTE: This step is only required if previously removed. 2. NOTE: This step is only

© 2011-2025 Copyright www.rrevoque.org