Range Rover Evoque: Front Seat Cushion Cover
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Prior to carrying out the step by step procedure below, Steps 2 and 3 must be followed for knowledge on how to correctly install and care for the seat cover.
2.
3.
4. If required, follow the steps below to carry out the removal and installation procedure.
5. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
6. Refer to: Front Seat Control Switch (501-10 Seating, Removal and Installation).
7. Refer to: Front Seat (501-10 Seating, Removal and Installation).
8. NOTE: If equipped.
9.
10.
11.
12.
Vehicles with heated front seats
13. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
Non NAS vehicles
14. CAUTION: Make sure the component is aligned as shown.
All vehicles
15.
16.
17.
18. WARNING: Wear safety goggles and protective gloves.
19. WARNING: Wear safety goggles and protective gloves.
Installation
1. NOTES:
Make sure that new hog rings are installed.
Use hog ring pliers to close the hog rings. Do not use any other tool. The hog rings must be closed to overlap as illustrated.
2. NOTE: Make sure that the hogrings are installed in the sequence shown.
3. To install, reverse the removal procedure.
READ NEXT:
Rear Seat Cushion Cover
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Prior to carrying out the step by step procedure below, Steps 2
and 3 must be followed for knowledge on how to correc
Front Seat Backrest Heater Mat
Removal
WARNINGS:
To avoid accidental deployment and possible personal injury, the backup
power supply must be depleted before
repairing or replacing any air bag supplemental restraint system (SRS)
Rear Seat Backrest Cover 3-Door
Removal
NOTES:
This procedure covers the removal and installation of both rear seat
backrests and the LH rear seat backrest cover.
The RH rear seat backrest cover is similar. All notes and cautions
SEE MORE:
Drive selector
P should normally be selected before switching
off the engine. If any other gear is selected at
turn off, the selector will move to P before
retracting into the centre console.
If the engine is switched off with N selected, the
system will wait for 10 minutes before
selecting P. This time dela
Tyre pressures
Never drive your vehicle if
the tyre
pressures are incorrect.
Pressure checks should only be
carried out when the tyres are cold,
and the vehicle has been stationary
for more than three hours. A hot tyre
at, or below, recommended cold
inflation pressure, is dangerously
under-inflated.
If
