Range Rover Evoque manuals

Range Rover Evoque: Intake Manifold

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Engine / Engine - GTDi 2.0L Petrol / Intake Manifold

Removal

NOTES:

Removal steps in this procedure may contain installation details.

Some illustrations may show the engine removed for clarity.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

3. Refer to: Engine Cover - GTDi 2.0L Petrol (501-05 Interior Trim and Ornamentation, Removal and Installation).

4.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

5.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

6.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

7.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

8.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

9.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

10.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

11. NOTE: Do not disassemble further if the component is removed for access only. Torque: 8 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

12.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

13. Torque: 5 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

Installation

1. To install, reverse the removal procedure.

2. CAUTIONS:

Tighten the bolts in the sequence shown.

Make sure that the mating faces are clean and free of foreign material.

Torque: 20 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

READ NEXT:

 Oil Cooler

Removal NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Disconnect the battery

 Oil Pan

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this proc

 Oil Pump

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this proc

SEE MORE:

 Front Stabilizer Bar AWD

Removal CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. NOTES: Only use clean water as a lubricant for the bushing, if required. Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stan

 Transmission Description - System Operation and Component Description

Control Diagram NOTE: A = Hardwired; D = High Speed Controller Area Network (CAN) bus; O = Local Interconnect Network ( LIN) Battery Battery Junction Box (BJB) Engine Control Module (ECM) Central Junction Box (CJB) Transmission paddle switches Clockspring Auxiliary battery module Transmis

© 2011-2025 Copyright www.rrevoque.org