Range Rover Evoque: Pairing and connecting from the touch screen
1. Switch on your mobile phone’s Bluetooth® connection. Make sure that your mobile phone is in Bluetooth® discoverable mode, sometimes referred to as find me mode (see your phone’s operating instructions for more information).
2. Switch the ignition on and ensure that the touch screen is active.
3. From the home menu select Phone.
4. A menu will appear. Select Search new.
5. Select Vehicle to device option.
6. Identify your phone from the displayed list and select the corresponding Pair and connect option.
Note: If more than 5 devices are detected, it may be necessary to use the scroll bar to see the entire list.
7. When prompted, enter the PIN code into your phone. See your phone’s operating instructions for further information.
8. Once your phone is paired and connected to the system, a confirmation message will be displayed before switching to the Digit Dial screen.
Note: Due to the duration of a Bluetooth®
search, it is advised that the timeout to home
screen feature is switched off before
attempting to search for Bluetooth® devices.
This setting can be changed within Vehicle,
Syst settings, Display set, Timeout to home
screen.
READ NEXT:
Changing the connected phone
Up to 10 mobile phones can be paired with the
vehicle in the same way. However, only one can
be connected and ready for use as a phone at
any one time.
To connect a different paired phone, follow
Touch screen icons
Connect. Use to send or accept
a call and access last 10 dialled
numbers.
Disconnect. Use to end or reject
a call.
No phone connected.
Phone signal strength indicator.
Phone battery l
Steering wheel icons
Connect. Press and release to
send or accept a call or to
access the last 10 dialled list.
Press and hold to access the
phonebook.
Disconnect. Use to end or reject
a call.
Voice control t
SEE MORE:
Intake Air Distribution and Filtering - GTDi 2.0L Petrol
Intake Air
Distribution and Filtering - Component Location
COMPONENT LOCATION
Purge hose from charcoal canister
Clean air purge hose
Clean air inlet ducts
Camshaft cover vent pipe connection
Sound generator duct
Sound generator
Air cleaner housing
Dirty air intake duct
Sound generator hos
Dynamic stability control (amber)
Dynamic stability control (amber)
Illuminates briefly when the
ignition is switched on and
extinguishes when the engine is
started. If the lamp flashes while driving, the
DSC system is active. If the lamp illuminates
continuously while driving, there is a fault with
the DSC system. The vehi
