Range Rover Evoque: Rear Quarter Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Rear Seat Cushion (501-10 Seating, Removal and Installation).
2. Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
3.
4.
5.
6. CAUTION: Discard the bolt.
NOTE: 5-door illustration shown, 3-door is similar.
Torque: 45 Nm
7.
8. NOTE: Do not disassemble further if the component is removed for access only.
9.
Installation
1. CAUTIONS:
Make sure that a new bolt is installed.
Make sure the safety belt is secure and correctly installed.
NOTE: Make sure the safety belt is operating correctly.
To install, reverse the removal procedure.
B-Pillar Upper Trim Panel 3-Door
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3. CAUTION: Discard the bolt.
NOTE: 5-door illustration shown, 3-door is similar.
Torque: 45 Nm
4.
5. Torque: 6 Nm
6.
7. NOTE: 5-door illustration shown, 3-door is similar.
Installation
1. WARNING: Make sure that a new bolt is installed.
CAUTION: Make sure the safety belt is secure and correctly installed.
NOTE: Make sure the safety belt is operating correctly.
To install, reverse the removal procedure.
Interior Trim and Ornamentation
Torque Specifications
READ NEXT:
Exterior Trim and Ornamentation
Torque Specifications
Rear Quarter Panel Moulding
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. NOTE: Discard the retaining clips.
Make sure that the centre
Rear View Mirrors
Rear View Mirrors - Component Location
NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive)
installation similar.
DDM (driver door module)
Driver exterior mirror
Exterior mirro
SEE MORE:
Towing the vehicle on four wheels
If the vehicle battery is
disconnected or
disabled, do NOT attempt to tow the
vehicle. Towing may result in serious
damage to the transmission.
The vehicle should NOT be towed on all four
wheels. However, if the vehicle cannot be
recovered by using the correct method, please
adhere to the
Hdc operation
With HDC engaged, standard descent speed
will not exceed 20km/h (12.4mph).
While the green warning lamp is continuously
illuminated, HDC target speed can be modified
using the cruise control steering wheel
switches, as follows:
- To increase speed, press and hold switch
(2) until the green po
