Range Rover Evoque: Transmission Control Module (TCM) TD4 2.2L Diesel
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Automatic Transmission & Transaxle / Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic
Transmission / Transmission Control Module (TCM) TD4 2.2L
Diesel
Removal
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Refer to: Air Cleaner (303-12, Removal and Installation).
3.
4.
5. CAUTION: Discard the component.
6.
7.
Installation
1. Torque: 25 Nm
2.
3. Torque:
- M10 47 Nm
- M8 24 Nm
4. CAUTION: Make sure that new components are installed.
NOTE: Do not fully tighten the clamp at this stage.
5. Torque: 10 Nm
6. Torque: 10 Nm
7. Refer to: Air Cleaner (303-12, Removal and Installation).
8. Reconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
9.
- Using the diagnostic tool, calibrate the transmission control module (TCM).
- Using the diagnostic tool, re-calibrate the gear shift module (GSM).
READ NEXT:
Torque Converter Seal TD4 2.2L Diesel
Special Tool(s)
307-597
Installer, Torque Converter Seal
307-613
Holding Pins, Torque Converter
Removal
NOTE: Some variation in the illustrations may occur, but the essential
information is always co
Transmission Fluid Pan TD4 2.2L Diesel
Removal
CAUTION: Extreme cleanliness must be exercised when handling this
component.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. WARNING
Transmission TD4 2.2L Diesel - Removal
Removal
Special Tool(s)
205-857
Remover, Halfshaft
303-021
Engine support bracket
303-662
Support Beam Arm and Hook Assembly, Engine
General Equipment
Transmission jack
NOTE: Some variation in the
SEE MORE:
Front Side Member Closing Panel
Removal
NOTES:
The front side member closing panel is manufactured from RP260.
The front side member closing panel is serviced as part of the front side member
and suspension top mount assembly.
This method describes the LH front side member closing panel, the RH side is
similar.
The panel is s
Pipes and Hoses
When removing or installing flexible hydraulic pipes and hoses, make sure
that the following procedures are observed to
make sure component serviceability:
Prior to removal, clean area around hose or pipe end which is to be
disconnected.
Obtain appropriate blanking plugs or caps before disconn
© 2011-2025 Copyright www.rrevoque.org
