Range Rover Evoque: Voice tutorial

To listen to a tutorial detailing the operation of the Voice system: - Briefly press the Voice button to start a voice session.

- Wait for the tone to sound, then say Voice tutorial.

Alternatively, the tutorial can be selected using the touch screen, as follows.

- Select Setup from the touch screen Home menu.

- Select Voice from the Setup menu.

- Select Operating guide from the Voice settings menu.

- Select Voice tutorial.

The voice tutorial can be cancelled at any time by touching the on-screen pop-up or by pressing and holding the Voice button.

READ NEXT:

 Voice training

This is a feature designed to enable the system to better recognise the vocal characteristics of a user, once the training has been completed. To carry out Voice training: - Select Setup from the

 Voicetags

Voicetags enable the user to personalise the Voice system so that a single name can be used to call-up a navigation destination, telephone number or radio channel. To add a Voicetag: 1. Briefly p

 Navigation poi voice commands

To request the display of POI (Point Of Interest) identifiers on the navigation display: - Say Navigation, followed by the name of the desired P.O.I category from the following list; - Petrol sta

SEE MORE:

 Front Stabilizer Bar AWD

Removal CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. NOTES: Only use clean water as a lubricant for the bushing, if required. Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stan

 Inner Back Panel Assembly

Removal NOTES: The inner back panel assembly is manufactured from mild steel. The panel is serviced less its weld studs. The new service panel is not fully spot welded when supplied. It is necessary to remove a section of one rear lamp mounting panel to enable removal and installation of the inn

© 2011-2025 Copyright www.rrevoque.org