Range Rover Evoque: Wheel alignment data (China)

Pedal travel (China)

READ NEXT:

 Pedal travel (China)

Both the brake and clutch pedal travel are set at the factory and are non-adjustable.

 Dimensions - coupe and 5 door

 Bulb specification chart

Before attempting to replace a bulb, ensure that both the affected lamp and the vehicle's ignition, are turned off. If the circuit remains live, a short circuit can occur which may damage the

SEE MORE:

 Instrument Panel GTDi 2.0L Petrol

Removal NOTE: Removal steps in this procedure may contain installation details. 1. Make the SRS system safe. Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation). 2. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and

 Programming

Programming With the engine switched off; 1. Ensure that the ignition system is on. 2. Hold the signal emitting end of the original garage door opener hand-held transmitter 50 to 150 mm (2 to 6 inches) away from the HomeLink transceiver in the rear-view mirror, keeping the indicator lamp in

© 2011-2025 Copyright www.rrevoque.org