Range Rover Evoque: Lumbar Assembly Vehicles With: Sports Seats
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Side Air Bag Module - Vehicles With: Sports Seats (501-20B Supplemental Restraint System, Removal and Installation).
4.
5.
6.
7.
Installation
1. To install, reverse the removal procedure.
Front Seat Tilt Assembly Vehicles With: Sports Seats
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Side Air Bag Module - Vehicles With: Sports Seats (501-20B Supplemental Restraint System, Removal and Installation).
4.
5.
6. NOTE: Repeat the procedure for the other side.
7.
8.
9.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Front Seat Cushion Cover Vehicles With: Sports Seats
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Prior to carrying out the step by step procedure below, Steps 2
and 3 must be followed for knowledge on
Driver Seat Cushion Vehicles With: Sports Seats
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Spe
Passenger Seat Cushion Vehicles With: Sports Seats
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Spe
SEE MORE:
Leather
Use only cleaning products
specifically
designed for use on leather. Do not use
solvents. Do not use chemical, alcohol,
or abrasive materials, as they will cause
rapid deterioration of the leather. The
use of products which are not approved
will invalidate your warranty.
If you are in any
Back Panel
Removal
NOTES:
The back panel is manufactured from mild steel, it includes the bumper
retaining bracket.
It is necessary to remove a section of both rear lamp mounting panels to enable
removal and installation of the back panel.
1. The back panel is replaced in conjunction with:
Rear bumper cov
