Range Rover Evoque: Rear Lower Arm FWD

Removal

NOTES:

LH illustration shown, RH is similar.

Some variation in the illustrations may occur, but the essential information is always correct.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

3. NOTE: All wheel drive transmission illustrations shown, front wheel drive transmission is similar.

4. CAUTION: Note the fitted position of the special washer.

5.

6.

7. NOTE: Do not disassemble further if the component is removed for access only.

Installation

1. NOTE: This step is only required if previously removed.

2. CAUTION: Only tighten the nut and bolt finger-tight at this stage.

3. CAUTION: Only tighten the nut and bolt finger-tight at this stage.

4. CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Support weight of vehicle on a jack at the rear hub.

5.

6. Torque: 175 Nm

7. CAUTION: Note the fitted position of the special washer.

8. Torque: 175 Nm

9. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

10. Check and if necessary, adjust the rear wheel alignment

READ NEXT: