Range Rover Evoque: Rear seat access (coupe models)

The front seats tilt and power slide forwards for entry to and exit from the rear seats. Operation is controlled by a lever and switch.

1. Lift the locking lever and pivot the seatback

1. Lift the locking lever and pivot the seatback forwards.

2. Press the front of the switch to power the seat forwards.

3. To return the seat, pivot the seatback until it locks into its previous position, then press and hold the rear of the switch to power the seat rearwards until it locks into position.

READ NEXT:

 Rear seats

 Folding and raising the rear seats

Folding and raising the rear seats The split fold rear seat of 5 door models can be folded completely, or partially at 60/40 split, to accommodate loads and still retain seating for passengers.

 Rear seat head restraints

Adjust the head restraint so that the top of the head restraint is above the centre line of the head. An incorrectly adjusted head restraint increases the risk of death or serious injury in the

SEE MORE:

 Air Distribution and Filtering

Component Location NOTE: Right Hand Drive (RHD) shown, Left Hand Drive (LHD) similar COMPONENT LOCATION Passenger face level/side window register Side window vent Face level duct Side window duct Windshield duct Windshield vent Side window vent Driver face level/side window register Drive

 Inner Constant Velocity (CV) Joint Boot

Special Tool(s) 303-D121 Puller, General Purpose General Equipment Vise Removal NOTE: RH inner constant velocity joint boot shown, LH is similar. 1. Refer to: Front Halfshaft LH (205-04 Front Drive Halfshafts, Removal and Installation). Refer to: Front Halfshaft RH - LHD AWD/RHD AWD (205-04 Fron

© 2011-2025 Copyright www.rrevoque.org