Range Rover Evoque: Stalled adjustment

movement stops unexpectedly If seat movement stops unexpectedly during adjustment check for any obstructions and remove.

Once any obstructions have been removed the seat adjustment mechanism can be reset as follows.

Operate the button again to continue the stalled adjustment. When seat movement resumes hold the button until the end of travel in that direction has been reached. The seat position can now be carried out as normal.

Note: If no obstructions can be seen, but normal adjustment cannot be carried out without stalling, contact your Land Rover Dealer/Approved Repairer.

READ NEXT:

 Sitting in the correct position

The driver and front seat passenger must not ride with the seat fully reclined. Do not adjust the seat while the vehicle is moving. The seat, head restraint, seat belt and airbags, all con

 Memory seats

Front seat positions can be saved to vehicle memory. Once you have adjusted the power operated driver’s seat and the exterior mirrors, the vehicle can memorise the settings for future use. See

 Easy entry/exit

When Easy entry/exit is configured, the driver’s seat will automatically lower when the ignition is switched off and the door release lever is used. Upon returning to the vehicle, when the drive

SEE MORE:

 Fuel Pump

Removal WARNING: This procedure involves fuel handling. Be prepared for fuel spillage at all times and always observe fuel handling precautions. Failure to follow these instructions may result in personal injury. NOTE: Removal steps in this procedure may contain installation details. 1. Disconnect

 Daytime Running Lamps (DRL)

Daytime Running Lamps (DRL) Principles of Operation For a detailed description of the Daytime Running Lamps (DRL) and operation, refer to the relevant Description and Operation section. REFER to: Daytime Running Lamps (DRL) (417-04 Daytime Running Lamps (DRL), Description and Operation). Inspecti

© 2011-2025 Copyright www.rrevoque.org