Range Rover Evoque: Steep slopes

If the vehicle is stationary on a steep, slippery slope, it may begin to slide even with the brakes applied. This is because without wheel rotation, the ABS cannot determine vehicle movement.

To counteract this, briefly release the brakes to allow some wheel rotation. Then re-apply the brakes to allow ABS to gain control.

READ NEXT:

 Emergency brake assist (EBA)

If the driver rapidly applies the brakes, EBA automatically boosts the braking force to its maximum, in order to bring the vehicle to a halt as quickly as possible. If the driver applies the brake

 Electronic brake distribution (EBD)

EBD controls the balance of braking forces supplied to the front and rear wheels, in order to maintain maximum braking efficiency. If the vehicle has a light load (only the driver in the vehicle f

 Electric parking brake (EPD)

The parking brake operates on the rear wheels. Therefore, secure parking of the vehicle is dependent on being on a hard and stable surface. Do not rely on the parking brake to operate effectiv

SEE MORE:

 Fender Apron Panel Front Reinforcement

Removal NOTES: The fender apron panel front reinforcement is manufactured from RP220 and mild steel. The panel is serviced less its weld studs 1. In this procedure, to make sure the vehicle is correctly aligned, it must be placed on an approved alignment jig. 2. The front side member and fender a

 Lower Arm

Removal CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. NOTES: RH illustration shown, LH is similar. Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the ve

© 2011-2025 Copyright www.rrevoque.org