Range Rover Evoque: Stop/start (manual transmission only)

The Stop/Start system has been designed to improve fuel efficiency. The system is automatically activated when the ignition is switched on.

When the engine has been stopped by the stop/start system, the ECO icon will illuminate.

When the vehicle comes to a stop,

When the vehicle comes to a stop, neutral is selected and the clutch is fully released, the engine automatically switches off.

When the clutch is depressed prior to selecting a gear, the engine automatically restarts.

READ NEXT:

 Conditions preventing automatic engine stop

The engine will not automatically stop if:<> - the external temperature is below approximately 0°C (32°F) - the external temperature is above approximately40°C (104°F) - engine has not re

 Conditions causing automatic engine restart

The engine will automatically start if:<> - climate control system demand increases - the vehicle’s speed reaches approximately 4km/h (2.5mph) - HDC or a Terrain Response special program ar

 Disabling stop/start

Disabling stop/start To switch the system off (preventing automatic stop/start) press the ECO switch. The LED indicator will extinguish to confirm that the system is off. Note: The engine will

SEE MORE:

 Front Halfshaft LH

Special Tool(s) 205-857 Remover, Halfshaft Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Do not allow halfshafts to hang unsupported at one end or joint damage will occur. Make sure the halfshaft constant velocity (CV) joints do not over art

 Rear Bumper Mounting

Removal NOTE: The rear bumper mounting is manufactured from mild steel. 1. In this procedure, to make sure the vehicle is correctly aligned, it must be placed on an approved alignment jig. 2. The rear bumper mounting is replaced in conjunction with: Rear bumper cover Rear bumper Back panel 3.

© 2011-2025 Copyright www.rrevoque.org