Range Rover Evoque: Throttle Body

Removal

NOTES:

Removal steps in this procedure may contain installation details.

Some illustrations may show the engine removed for clarity.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Refer to: Engine Cover - GTDi 2.0L Petrol (501-05 Interior Trim and Ornamentation, Removal and Installation).

3. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).

4.

Range Rover Evoque. Fuel Charging and Controls - GTDi 2.0L Petrol

5.

Range Rover Evoque. Fuel Charging and Controls - GTDi 2.0L Petrol

6.

Range Rover Evoque. Fuel Charging and Controls - GTDi 2.0L Petrol

7. NOTE: Install a new O-ring seal. Torque: 8 Nm

Range Rover Evoque. Fuel Charging and Controls - GTDi 2.0L Petrol

Installation

1. To install, reverse the removal procedure.

Fuel Injectors

Removal

1. Refer to: Fuel Rail (303-04C Fuel Charging and Controls - GTDi 2.0L Petrol, Removal and Installation).

Installation

1. To install, reverse the removal procedure.

Fuel Charging Wiring Harness

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

3. Refer to: Intake Manifold (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).

4.

Range Rover Evoque. Fuel Charging and Controls - GTDi 2.0L Petrol

5.

Range Rover Evoque. Fuel Charging and Controls - GTDi 2.0L Petrol

Installation

1. To install, reverse the removal procedure.

READ NEXT:

 Fuel Rail

Special Tool(s) 310-198 Installer, Teflon Seal 310-199 Re-shape Tool, Teflon Seal Removal CAUTION: Make sure that all openings are sealed. Use new blanking caps. NOTE: Some variation in the illustrat

 Fuel Pump

Removal WARNING: This procedure involves fuel handling. Be prepared for fuel spillage at all times and always observe fuel handling precautions. Failure to follow these instructions may result in pe

 Fuel Charging and Controls - Turbocharger - GTDi 2.0L Petrol

Torque Specifications Turbocharger Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always

SEE MORE:

 Inner Constant Velocity (CV) Joint Boot

Special Tool(s) 303-D121 Puller, General Purpose General Equipment Vise Removal NOTE: RH inner constant velocity joint boot shown, LH is similar. 1. Refer to: Front Halfshaft LH (205-04 Front Drive Halfshafts, Removal and Installation). Refer to: Front Halfshaft RH - LHD AWD/RHD AWD (205-04 Fron

 Engine Wiring Harness TD4 2.2L Diesel, Vehicles With: AWF21 6-Speed Automatic Transmission

Removal CAUTIONS: Make sure that the wiring harness is not twisted or damaged on removal. Failure to follow this instruction may result in damage to the vehicle. Take extra care not to damage the wiring harness clips. NOTES: Some variation in the illustrations may occur, but the essential informa

© 2011-2025 Copyright www.rrevoque.org