Range Rover Evoque: Using traction devices
Only use traction devices in
heavy
snow conditions, on hard road
surfaces.
Dynamic Stability Control (DSC) must
be switched off when using traction
devices.
Never exceed 50 km/h (30 mph) when
traction devices are fitted.
Never fit traction devices to a
temporary use spare wheel.
Land Rover approved traction devices may be used to improve traction on a hard road surface in heavy snow conditions. They should not be used in off-road conditions.
If it becomes necessary to fit traction devices, the following points must be observed: - Only Land Rover approved traction devices should be used on the vehicle. Only Land Rover approved traction devices have been tested to ensure that they do not cause damage to the vehicle. Contact your Land Rover Dealer/Authorised Repairer for information.
- The wheels and tyres fitted must conform to the specifications of the original equipment.
- Do not fit traction devices to 18, 19 or 20inch diameter wheels.
- Single sided Spike-spyder traction devices or snow chains can be fitted to only the front wheels of vehicles fitted with 17inch diameter wheels.
- Always read, understand and follow the traction device manufacturer's instructions.
- Avoid tyre/vehicle damage, by removing the traction devices as soon as the conditions allow.
READ NEXT:
Tpms inflation pressure compensation
If your vehicle is fitted with 18, 19 or 20 inch
wheels with TPMS, they can be replaced with
17 inch wheels with TPMS, so enabling the use
of snow chains or traction devices.
Tyre pressures of veh
Recovery
The method for recovery/ transportation of the
vehicle is on a transporter or trailer designed
for that purpose.
Ensure that transportation is carried out by
suitably qualified person and that the
SEE MORE:
Component Description
DOOR LATCHES
Door interior lock/unlock button
Door interior release handle
Door lock exterior release cable
Emergency mechanical door lock (front LH door only)
Exterior door handle lock cover
Exterior door handle
Door latch
Electrical connection to door control module
Door lock interior r
Automatic transmission
The rotary drive selector rotates in either
direction. At engine start up, the selector
elevates out of its parked position.
1. To select D (Drive) or R (Reverse) gear,
apply the foot brake then rotate the drive
selector. The related LED by the selector
will illuminate.
Note: If pressure is
