Range Rover Evoque manuals

Range Rover Evoque: Changing a road wheel

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Wheel changing / Changing a road wheel

Changing a road wheel
Changing a road wheel

1. Temporary spare wheel locking ring.

2. Temporary spare wheel retaining bolt.

3. Tool kit retaining bolt.

4. Jack.

5. Wheel brace.

should be After use, the tool kit should be returned to the under floor storage area and correctly stowed.
The spare wheel is heavy and if handled incorrectly may cause injury.
Use extreme caution when lifting or manoeuvring the wheels.
Always secure the spare wheel, or the removed wheel, in the correct position using the retaining bolt.

Always remove the temporary spare wheel before jacking the vehicle.

Note: Examine the jack occasionally, clean and grease the moving parts, particularly the screw thread, to prevent corrosion.

READ NEXT:

 Removing the temporary spare wheel

Remove the spare wheel prior to jacking the vehicle, to avoid destabilising the vehicle when raised. Do not use power tools to loosen the spare wheel. Doing so may damage the mechanism. 1.

 Temporary spare wheel

Always adhere to the instructions given on the temporary use spare wheel warning label. Failure to comply can be dangerous. When a temporary use spare wheel is fitted, drive with caution and r

 Using wheel chocks

Note: Wheel chocks are not supplied as part of the tool kit. Wheel chocks are a useful addition to a vehicle tool kit. Note the following advice when using wheel chocks. Before raising the vehic

SEE MORE:

 Body Repairs - Corrosion Protection

Corrosion Protection Galvanic Corrosion Galvanic corrosion is the cross-contamination of dissimilar metals, in this case aluminium and steel. Avoidance of galvanic corrosion is an important issue to be considered in the repair of aluminium bodied vehicles. Precautions to prevent the contamination

 Windscreen wipers

Windscreen wipers 1. Rotate the collar to adjust the intermittent period. The intermittent delay period will vary and is controlled by either vehicle speed or a rain sensor. The control must be in position (4) to be operational. This is a dealer configurable option. 2. High speed wipe. 3.

© 2011-2025 Copyright www.rrevoque.org