Range Rover Evoque: Decreasing cruise speed

To reduce cruising speed, press and hold control (4). Release the switch when the desired speed is reached, the new speed will be set and maintained.

The set speed can be decreased in steps of 2km/h (1mph), by briefly pressing control (4).

READ NEXT:

 Suspending and resuming cruise control

Suspend cruise control with a single press of control (3). To resume cruise control at the previous set speed, press control (2). RES (2) should be used only if the driver is aware of the set

 Automatic switch off

Cruise control will switch off but the set speed will remain in the memory when: - The CAN button (3) is pressed. - The brake pedal is pressed. - Speed falls below 30km/h (18mph). - Neutral, Park

 Cruise eco data

Diesel only When enabled, a CO2 emission indicator is displayed in the message centre. The higher the numeric reading, the more CO2 is being emitted and the more fuel is being used. See 56, VEH

SEE MORE:

 Glass Roof Panel Blind Motor

Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essential information is always correct. All vehicles 1. NOTE: The step must be carried out on both sides. Refer to: A-Pillar Trim Panel (501-05 Interior Trim and

 Transfer Case Seal RH GTDi 2.0L Petrol

Special Tool(s) 100-012 Slide Hammer 205-872 Installer, Transfer Case Seal 308-615 Remover, Seals 308-617 Depth Drill, Seal Remover Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essential information is alway

© 2011-2025 Copyright www.rrevoque.org