Range Rover Evoque: Driver override options
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Terrain response / Driver override options
Although Dynamic Stability Control is automatically engaged when a special program is selected, it can be turned off if required. See 91, DISABLING DSC.
Hill Descent Control (HDC) will be automatically engaged for some terrain response programs. If required it can be deselected or engaged independently of Terrain response. See 96, HILL DESCENT CONTROL (HDC) CONTROLS.
The HDC status will be displayed on the message centre whether it is engaged, or disengaged, by the system or by the driver.
READ NEXT:
System difficulties
Use of an incorrect program
will impair
the vehicle's response to the terrain and
can reduce the life of the suspension
and drive systems.
If the system becomes partially inoperable for
any re
Terrain response messages
Messages relating to the Terrain response
system are displayed in the message centre.
See 56, INSTRUMENT PANEL.
Most of the messages that appear will be for
information only and require no driver
SEE MORE:
Engine Emission Control - GTDi 2.0L Petrol
Emission Control -
Component Location
COMPONENT LOCATION
Intake manifold
Bolt (8 off)
Crankcase ventilation hose
Oil separator
Gasket
Camshaft cover
Lower clean air inlet duct
Upper clean air inlet duct
Camshaft cover vent hose
Air cleaner housing
Engine Emission Control -
Overview
OVER
Inner Constant Velocity (CV) Joint Boot
Special Tool(s)
303-D121
Puller, General Purpose
General Equipment
Vise
Removal
NOTE: RH inner constant velocity joint boot shown, LH is similar.
1. Refer to: Rear Halfshaft LH (205-05 Rear Drive Halfshafts, Removal
and Installation).
Refer to: Rear Halfshaft RH (205-05 Rear Drive Halfshafts, Re
© 2011-2025 Copyright www.rrevoque.org
