Range Rover Evoque manuals

Range Rover Evoque: Dynamic stability control (DSC)

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Stability control / Dynamic stability control (DSC)

DSC is automatically enabled each time the engine is started, and is automatically enabled by some of the Terrain response special programs.

for The vehicle is not designed for cornering at the same speed as conventional passenger cars any more than a low-slung sports car is designed to perform satisfactorily under off-road conditions. If at all possible, avoid sharp turns or abrupt manoeuvres. As with other vehicles of this type, failure to operate the vehicle correctly may result in loss of control or vehicle rollover.

READ NEXT:

 Dsc warning lamp

The amber DSC warning lamp in the instrument panel illuminates briefly when the ignition is switched on and extinguishes when the engine is started. If the lamp flashes while driving, the DSC

 Disabling dsc

Safety may be reduced by inappropriately disabling DSC. In the majority of driving situations, and particularly on-road, it is recommended that you do not disable DSC. In some driving condition

 Re-enabling dsc

DSC is re-enabled by one of the following: - Press and briefly hold the DSC OFF switch. - Stop and restart the engine. - Select a new Terrain Response special program.

SEE MORE:

 Epb manual use

Epb manual use 1. To apply the parking brake, with the vehicle stationary, pull up the lever and release it. The parking brake warning lamp will illuminate. It is important to confirm that the lamp is continuously illuminated (not flashing), as this indicates the brake has been correctly

 Fuel Fired Booster Heater AWD

Component Location COMPONENT LOCATION - VEHICLES WITHOUT FFBH REMOTE CONTROL ATC (automatic temperature control) module Fuel Fired Booster Heater (FFBH) Auxiliary coolant pump Ambient air temperature sensor Auxiliary fuel pump COMPONENT LOCATION - VEHICLES WITH FFBH REMOTE CONTROL ATC mod

© 2011-2025 Copyright www.rrevoque.org