Range Rover Evoque: Front Stabilizer Bar AWD
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.
NOTES:
Only use clean water as a lubricant for the bushing, if required.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Remove the front wheels and tires.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
3. CAUTION: Make sure that new bolts are installed.
- Torque: 40 Nm
- Using a suitable tie strap, secure the driveshaft.
4. Refer to: Catalytic Converter (309-00A Exhaust System - GTDi 2.0L Petrol, Removal and Installation).
Refer to: Catalytic Converter - Vehicles Without: Diesel Particulate Filter (DPF) (309-00B Exhaust System - TD4 2.2L Diesel, Removal and Installation).
Refer to: Catalytic Converter - Vehicles With: Diesel Particulate Filter (DPF) (309-00B Exhaust System - TD4 2.2L Diesel, Removal and Installation).
5. WARNING: Make sure that a new nut is installed.
CAUTION: Make sure that the ball joint ball does not rotate.
- Torque: 60 Nm
- Repeat the above step for the other side.
6. WARNING: Make sure that new nuts are installed.
- Torque:
Stage 1: 175 Nm
Stage 2: 175 Nm
- Repeat the above step for the other side.
7. NOTE: Subframe shown removed for clarity.
8. Inspect the components and install new if damaged or worn.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Front Stabilizer Bar Bushing
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure
Wheel Knuckle
Special Tool(s)
205-754A
Splitter, Ball Joints
205-857
Remover, Halfshaft
JLR-204-804
Lever, Wheel Knuckle
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
sus
Front Shock Absorber Vehicles Without: Dynamic
Suspension
General Equipment
Suspension Spring Compressor
Vise
Removal
WARNINGS:
Make sure the spring compressor Safe Working Load (SWL) meets or exceeds
the spring rating quoted in the
Specifcations sectio
SEE MORE:
Maintenance Schedules - Gasoline Engines
Under Bonnet View
1A - Brake/clutch fluid reservoir caps (beneath cover) left-hand drive (LHD)
vehicles.
1B - Brake/clutch fluid reservoir caps (beneath cover) right-hand drive
(RHD) vehicles.
2 - Engine oil filler cap.
3 - Oil level dipstick.
4 - Washer fluid filler cap.
5 - Engine cool
Diesel Fuel System Health and Safety Precautions
WARNINGS:
Fuel may not give adequate warning before toxic or harmful effects arise.
Exposure to fuel can be harmful and can cause severe health damage or death.
Provide adequate ventilation when working on fuel systems.
Extreme care must be exercised when handling hot fluids. Always wash off spi
