Range Rover Evoque: Anti-trap protection

blind onto Closing a window or roof blind onto any part of the body can result in serious injury.
Before closing a window or the roof blind, ensure that no occupants have any part of their body in a position where it could be trapped. Even with an anti-trap system death or serious injury could occur.

Anti-trap protection will stop window or roof blind movement if an obstruction or resistance is detected. Check the window or roof blind and its aperture and remove any obstructions (e.g.

ice, etc.).

If it is still necessary to raise the window, the override procedure is as follows: 1. Attempt to close the window, anti-trap will prevent closure and lower the window slightly.

2. Within ten seconds attempt to raise the window again, anti-trap will prevent closure and lower the window slightly.

3. Attempt to close the window for a third time, this time hold the switch in the close position. Hold until closed.

Note: If this procedure fails to remove the blockage, the window operation may need to be reset.

READ NEXT:

 Resonance with lowered windows

if a resonance or booming sound occurs when a rear window is open, lowering an adjacent front window by approximately 25mm (1 inch) will eliminate the condition.

 Mirrors

 Exterior mirrors

Exterior mirrors 1. Mirror selector switches. Press to select the left or right mirror. 2. Mirror adjustment switch. Move up/down/left or right to adjust the mirror glass. 3. Press both select

SEE MORE:

 Rear View Mirrors

Rear View Mirrors - Component Location NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive) installation similar. DDM (driver door module) Driver exterior mirror Exterior mirror switches Memory switches Interior mirror (automatic dimming version shown) PDM (passenger door

 Manual Transmission/Transaxle and Clutch - General Information

Lubricant Capacities General Specification Torque Specifications Clutch System Bleeding NOTE: Some variation in the illustrations may occur, but the essential information is always correct. All vehicles 1. Check that all the clutch line connections are tight and that there are no signs of leaks

© 2011-2025 Copyright www.rrevoque.org