Range Rover Evoque: Automatic switch off

Cruise control will switch off but the set speed will remain in the memory when: - The CAN button (3) is pressed.

- The brake pedal is pressed.

- Speed falls below 30km/h (18mph).

- Neutral, Park or Reverse gear is selected on vehicles with automatic transmission.

- Dynamic Stability Control is operating.

- The difference between the actual and set speed is too great.

- The vehicle reaches a speed of 170km/h (105.6mph).

- The accelerator pedal is used to accelerate beyond the set speed for too long a period.

Cruise control will switch off and clear the memory when: - The ignition system is switched off.

- A fault occurs. The cruise control system will switch off and cannot be used until the fault is cleared.

READ NEXT:

 Cruise eco data

Diesel only When enabled, a CO2 emission indicator is displayed in the message centre. The higher the numeric reading, the more CO2 is being emitted and the more fuel is being used. See 56, VEH

 Stability control

 Dynamic stability control (DSC)

DSC is automatically enabled each time the engine is started, and is automatically enabled by some of the Terrain response special programs. The vehicle is not designed for cornering at the sa

SEE MORE:

 Component Description

DOOR LATCHES Door interior lock/unlock button Door interior release handle Door lock exterior release cable Emergency mechanical door lock (front LH door only) Exterior door handle lock cover Exterior door handle Door latch Electrical connection to door control module Door lock interior r

 Engine Wiring Harness TD4 2.2L Diesel, Vehicles With: AWF21 6-Speed Automatic Transmission

Removal CAUTIONS: Make sure that the wiring harness is not twisted or damaged on removal. Failure to follow this instruction may result in damage to the vehicle. Take extra care not to damage the wiring harness clips. NOTES: Some variation in the illustrations may occur, but the essential informa

© 2011-2025 Copyright www.rrevoque.org