Range Rover Evoque: Changing the smart key batttery
When the battery needs renewing, there will be a significant decrease in the effective range and the message SMART KEY BATTERY LOW will be displayed in the message centre.
To renew the battery: 1. Slide open the side cover.
2. Remove the emergency key and fit into the receiver.
3. With the key unfolded, twist it to split the Smart Key case open.
4. Remove the old battery and fit a new CR2032 type battery (available from your Dealer), with the positive (+) side upwards.
Note: Avoid touching the new battery, as moisture/oil from fingers can reduce battery life and corrode the contacts.
Refit the parts in reverse order, ensuring that they click securely into place.
Battery disposal: Used batteries must be disposed of correctly, as they contain harmful substances.
Seek advice on disposal from your Dealer and/or your local authority.
READ NEXT:
Locking and arming the alarm
CAUTION: No modifications or
additions should be made to the
anti-theft system. Such changes could
cause the system to malfunction.
There are two levels of security:
- Single locking. With all d
Lock confirmation
If you are uncertain whether the vehicle is
locked and armed (either by single or double
locking), press either the Smart Key lock
button or, if Keyless entry is fitted, touch an
exterior door han
SEE MORE:
Rear Wheel Bearing
Special Tool(s)
204-250
Wheel bearing install and removal tool
204-305
Remover, Wheel Bearing
204-726
Remover/Installer, Wheel Bearing
JLR-204-806
Support Tool, Wheel Knuckle
JLR-204-809
Installer, Rear Wheel Bearing
JLR-204-810
Installer, Rear Wheel Bearing
General Equipment
Copper Hammer
Hydrau
Transfer Case Seal
RH GTDi 2.0L Petrol
Special Tool(s)
100-012
Slide Hammer
205-872
Installer, Transfer Case Seal
308-615
Remover, Seals
308-617
Depth Drill, Seal Remover
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
alway
